Velleman LEDS03RGB Uživatelský manuál stáhnout pdf (Strana 4)

LEDS03RGB

V. 01 – 07/02/2012 4 ©Velleman nv

4. Use

Refer to the illustrations on page 2 of this manual.

a. Installation

• Mount the LED strip in the desired location. The LED strip can be cut

every 10 cm (see [A]). The cut ends must be protected to avoid short-

circuits.

• Connect the LED strip to the controller [B2] (connecting tools not

included). Make sure to connect matching wire colours. Do not short-

circuit any wires.

• Connect the included power adaptor to the controller [B1]. Plug the

other end into the mains.

b. Use

• Aim the remote control [C] towards the IR LED [B3] of the controller to

control the output of the LED strip.

• Switch the LED strip on or off with the button on the remote control.

• Select the desired light output colour by pressing the corresponding

colour button on the remote control.

Note: If you want a different colour, you can define your own using the

DIY buttons. For more information, see further in this manual.

• To increase or decrease output brightness, press the or button

(8 gradations).

c. Using Effects

• Press the effect buttons to generate different effects: Auto, Flash,

Fade3 (3 colours), Fade7 (7 colours), Jump3 (3 colours), or Jump7

(7 colours).

• To increase the speed of the effects, press Quick. To decrease the

speed, press Slow.

• To pause the effect, press the button. Press the button again to

restart.

d. Creating Custom Colours

You can define and store up to 6 custom colours using the DIY1->6

buttons. When you press the DIY button, the LED strip will change to your

custom colour. For example, to store a colour for button DIY1:

• Press DIY1.

• Use the coloured and buttons to mix your own colour.

• Press DIY1 again to store the colour. The LED strip will blink once when

the colour is stored correctly.

1 2 3 4 5 6 7 8 9 ... 19 20

Žádné komentáře

Velleman LEDS03RGB Uživatelský manuál Strana 4