Velleman VTSS110 Uživatelský manuál stáhnout pdf (Strana 4)

VTSS110_v2 VELLEMAN 4

How to Clean a Tip?

• Set the temperature to 250°C.

• After the temperature has stabilized, clean the tip and check its condition. If the tip is deformed or badly worn,

replace it. If the solder-plated part of the tip is covered with black oxide, apply fresh solder containing flux and

clean the tip again.

• Switch off the unit and remove the cooled tip with the heat-resistant pad. Remaining oxides such as the yellow

discoloration on the shaft can be cleaned with isopropyl alcohol. Store the tip in a cool and dry place.

Recalibrating the Soldering Iron

• The soldering iron should be recalibrated each time you replace the soldering iron, heating element or tip.

• Connect the unit to the mains.

• Set the temperature control knob to 400°C.

• Switch on the unit and wait for the temperature to stabilize. Remove the CAL pot plug.

• After temperature stabilization, use a small Phillips-headed screwdriver and turn the CAL screw (clockwise to

increase, anticlockwise to decrease) until the tip thermometer reads 400°C. Replace the pot plug.

6. Troubleshooting

Problem Possible Cause Solution

The heater LED does not light

Not connected to the mains Connect to the mains

Blown fuse

Determine the cause of the blown

fuse, replace the fuse

The heater LED lights but the tip

does not heat

Soldering iron cord defective Have your dealer replace the cord

Defective heating element

Have your dealer replace the heating

element

The tip heats up intermittently

Oxidized or unclean tip Clean the tip

Badly calibrated soldering iron Recalibrate the soldering iron

Defective tip Replace the tip

7. Technical Specifications

Power Supply 230VAC / 50Hz

Dimensions Station 187 x 128 x 246mm

Total Weight 5.8kg

Soldering Iron

Power Consumption 60W

Temperature Range 200°C ~ 480°C

Input Voltage 24V

Heating Element PTC

Hot Air Gun

Power Consumption 450W

Temperature Range 100°C ~ 500°C

Air Capacity 23l/min

Heating Element metal heating core

For more info concerning this product, please visit our website www.velleman.eu.

The information in this manual is subject to change without prior notice.

CAUTION: Disconnect the unit from the mains prior to examining and maintaining. Failure to

do so ma

result in electroshocks.

1 2 3 4 5 6 7 8 9 ... 19 20

Komentáře k této Příručce

Žádné komentáře

Velleman VTSS110 Uživatelský manuál Strana 4

Komentáře k této Příručce

Související produkty a manuály pro Elektrické nářadí Velleman VTSS110