Velleman K8200 Uživatelský manuál stáhnout pdf (Strana 32)

If everything went right so far you know that the extruder will work, now we will test the HEATED BED PCB.

Make sure the temperature for the HEATED BED PCB is set at 50°C.

Now press the button “Heat Printbed”.

(When you do this you can also see an indicator light on the controller board lighting up, showing that HEATER 2 is

powered).

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 44 45

Žádné komentáře

Velleman K8200 Uživatelský manuál Strana 32